evolutionm.net - Home of the Lancer Evolution
Home Features Community Marketplace Registry Garage Store
Features
Features
Features Home
EvoM Features
EvoM News
EvoM Newsletters
EvoM Tech & FAQ
Project Cars
Vendor Corner
Image Gallery
Latest Articles
Wheel Wonderland Wheel Wonderland
Sublime Sakura Sublime Sakura
Everyday Performance, A Turnkey Solution Everyday Performance, A Turnkey Solution
The Modern Performance Car Drive The Modern Performance Car Drive
Project Evo X part 2: CBRD front mount and upper IC pipe Project Evo X part 2: CBRD front mount and upper IC pipe
Latest News
Shift 2: Unleashed Demo Event Shift 2: Unleashed Demo Event
Race Ramps Sweepstakes Race Ramps Sweepstakes
The 18th annual Evo/DSM Shootout The 18th annual Evo/DSM Shootout
IDRC Season Finale - LACR - Nov 13th and 14th! IDRC Season Finale - LACR - Nov 13th and 14th!
IDRC East Coast Finals - SEPT 25 - Maplegrove Raceway IDRC East Coast Finals - SEPT 25 - Maplegrove Raceway

Turbo Timer Install - US Lancer Turbo

Author: Robert Tallini
Page: 1
Last Updated: 5/4/2003

Required Tools/Parts:

  • Phillips Screwdriver
  • Wire Stripers
  • A splice connector
  • 95-99(2nd Gen) Eclipse Harness
  • Some Zip ties

Installation:

  1. On the steering wheel column you値l need to remove the 3 Phillips screws underneath and separate the upper plastic and lower plastic covers.The bottom cover will just slip off the ignition switch.


  2. On the left side of the column at the end of the ignition switch you値l see the connector.Disconnect it and use the 95-99 eclipse harness.


  3. Connect the male ends to the female ends and then connect the Turbo Timers wiring harness to the other connection on the 95-99 eclipse harness.

  4. Then run the Turbo Timer harness along the column on the same path the stock wiring is placed and tuck the rest under the dash.

  5. Replace top and bottom halves of column and re-install/tighten Phillips screws.

  6. Now figure out where you want to mount the timer.Once mounted you can plug in the timer to the harness.

  7. The turbo connects to the emergency brake (e-brake) to prevent theft and as a safety to remind you to engage the brake in order to prevent the car from rolling.

  8. To connect the harness to the e-brake, first identify the right wire according to the instructions.Then you値l need to remove the two Phillips screws located in the bottom of the center console storage area.

  9. The rest of the console is secured via clips that give when pulled up on.You値l need to pull the console up and forward slipping it over the e-brake.

  10. After doing this you値l see the wiring/connector to the e-brake.It is only one wire.Just splice into it connecting the wiring harness wire as well.

  11. Zip-tie all your wires out of the way and out of any danger of getting hit or cut.

  12. Replace the center console (reverse of removal) and you can now follow the instructions included with the Timer for proper setup.

Enjoy your new timer!



Print Version Send to Friend Page 1 of 1

© Copyright 2008, Internet Brands Inc.. All Rights Reserved.
About Us | Contact Us | Advertising | Jobs| Archives | Privacy | Terms | Link to Us







Diagnostic Information:
20 database queries total
Execution time = 0.06173 seconds
Cached: No