Question about Bosch 1000cc Injectors
#16
Warm start continues to work fine. In fact, the car seems to start far more quickly than with the oem injectors.
To prove my newbish ways, I haven't touch IPW adder as I have no clue what that is (or that it even existed).
I just installed the moddified Walbro 255lph HP unit and adjusted my latency's and scaling a little bit more. I am at work and did not bring in my laptop so I don't have the numbers handy. I will post more around lunch time.
Question, when I cruised around to adjust Mid Trims I forgot to update Mitsulogger with the scaling numbers I am using. Will this affect the Trim outputs numbers? I am going to spend a little bit more time to make sure the injectors are scaled properly, the numbers are very close now and I didn't want to find out I was way off base.
Thanks.
Dan
To prove my newbish ways, I haven't touch IPW adder as I have no clue what that is (or that it even existed).
I just installed the moddified Walbro 255lph HP unit and adjusted my latency's and scaling a little bit more. I am at work and did not bring in my laptop so I don't have the numbers handy. I will post more around lunch time.
Question, when I cruised around to adjust Mid Trims I forgot to update Mitsulogger with the scaling numbers I am using. Will this affect the Trim outputs numbers? I am going to spend a little bit more time to make sure the injectors are scaled properly, the numbers are very close now and I didn't want to find out I was way off base.
Thanks.
Dan
#21
EvoM Community Team
iTrader: (15)
Question, when I cruised around to adjust Mid Trims I forgot to update Mitsulogger with the scaling numbers I am using. Will this affect the Trim outputs numbers? I am going to spend a little bit more time to make sure the injectors are scaled properly, the numbers are very close now and I didn't want to find out I was way off base.
Thanks.
Dan
Thanks.
Dan
#25
Evolved Member
iTrader: (26)
Join Date: Oct 2005
Location: Pittsburgh
Posts: 1,712
Likes: 0
Received 0 Likes
on
0 Posts
See what your low, mid, and high work out to be..if they go over -5/+5 then you need to work on latency or scaling depending on which trim is off.
#29
What I will do when I get home is disconnect the battery (to reset fuel trims right? I just learned that today) and go for a cruise and let you guys know what kind of feedback I get.
Dan
#30
Evolved Member
iTrader: (26)
Join Date: Oct 2005
Location: Pittsburgh
Posts: 1,712
Likes: 0
Received 0 Likes
on
0 Posts
Gotcha, so far using Mitsulogger, the values seem to float around -2, 0, +1 and rarely +2.
What I will do when I get home is disconnect the battery (to reset fuel trims right? I just learned that today) and go for a cruise and let you guys know what kind of feedback I get.
Dan
What I will do when I get home is disconnect the battery (to reset fuel trims right? I just learned that today) and go for a cruise and let you guys know what kind of feedback I get.
Dan