Tephra V7 96530706 IC Control
#36
Evolving Member
Thread Starter
Ok will do,
So i can change all other parameters to get it to spray for me but leave the timers stock?
ill try that over the weekend and report back
So i can change all other parameters to get it to spray for me but leave the timers stock?
ill try that over the weekend and report back
#40
Evolving Member
Thread Starter
Ok so everything was stock other then the items to get it to spray when i rev it to see if its spraying
Nothing this is still not spraying, do you think the MAX Vehicle Speed is actually Min Vehicle Speed?
Nothing this is still not spraying, do you think the MAX Vehicle Speed is actually Min Vehicle Speed?
#42
Evolved Member
iTrader: (9)
My 94170715 has a IC Relay Timer On/Off Time @ 247e. It's wrong.
Original had a IC Relay Timer time @ 248a. Changing it to 8a will let you correctly program on/off for the relay in my car.
Found out the hard way. That relay controls compressor pressure via DV in my car per TPS100% application. Had it set to 10 yet after 2 seconds the DV would open (middle of 2nd gr) and boost would drop. Didn't pinpoint it until I was messing with the NLTS for fun at 2000rpm and would hear the damn relay enrgize after 2 sec
Original had a IC Relay Timer time @ 248a. Changing it to 8a will let you correctly program on/off for the relay in my car.
Found out the hard way. That relay controls compressor pressure via DV in my car per TPS100% application. Had it set to 10 yet after 2 seconds the DV would open (middle of 2nd gr) and boost would drop. Didn't pinpoint it until I was messing with the NLTS for fun at 2000rpm and would hear the damn relay enrgize after 2 sec
#44
Evolving Member
Thread Starter
I think i have a work around for this, well for me anyway
What i have done is set my ICS Spray on Knock (because this works), to spray on 0 Knock Sum Above 200load as this is when i want it to spray anyway, so for now this will do
Thanks
What i have done is set my ICS Spray on Knock (because this works), to spray on 0 Knock Sum Above 200load as this is when i want it to spray anyway, so for now this will do
Thanks
#45
SO i know this thread is old but its something i have recently started to try to get working on my DSM.
The guide mentioned in this thread can be found here:
http://www.mrtperformance.com.au/ima...IX-ICSpray.pdf
One key point I noticed in this write up was that the switch needed to be in the AUTO mode. Going to see if this is my issue on the dsm as i couldnt get it to trigger earlier.
The guide mentioned in this thread can be found here:
http://www.mrtperformance.com.au/ima...IX-ICSpray.pdf
One key point I noticed in this write up was that the switch needed to be in the AUTO mode. Going to see if this is my issue on the dsm as i couldnt get it to trigger earlier.