justastockevo

iTrader: (1)

i'm having a bit of trouble converting to SD and adjusting 3D ve table.

my values are going up to 190 points and car doesn't seem to react.
do i run too big of a value and should adjust scalings instead?

any 3d ve table examples, besides those already listed on forums? or someone i can speak with on the issue?

thanks!

And

post up your rom with a log so that I can see whats going on then could make some suggestions

justastockevo

iTrader: (1)

ok, found out a little bit, it seems that kpa-to-load should be used as rough adjustment and VE table is more of a fine tuning. this way VE values don't go thru the roof and fuelling is more or less predictable.

i'll keep playing with that and will report findings.