Who can help the trbotaxi pass inspection?!
#1
Who can help the trbotaxi pass inspection?!
Hey guys I'm wondering if anyone can give me a hand in getting the taxi to pass inspection, I just need my tune updated for the car to idle that's all. Don't need it drive or anything, literally just need to start and idle to pass the plug in.
I've been using an old tune but with all the changes I don't think the car will run anymore as I changed MAP sensors again. I can send you my tune that I've been using and can go from there. The old tune was also on a SD tune if that matters as ill need to keep using that anyway.
The car has an Omni 7 bar MAP sensor on it.
Stm 2.0
stm 650 cams
stm triple pumper w/ ASNU pumps
fic 2150s
omni 7 bar MAP
any help is greatly appreciated!!
I've been using an old tune but with all the changes I don't think the car will run anymore as I changed MAP sensors again. I can send you my tune that I've been using and can go from there. The old tune was also on a SD tune if that matters as ill need to keep using that anyway.
The car has an Omni 7 bar MAP sensor on it.
Stm 2.0
stm 650 cams
stm triple pumper w/ ASNU pumps
fic 2150s
omni 7 bar MAP
any help is greatly appreciated!!
Last edited by psphinx81; Sep 25, 2016 at 07:25 AM.
The following users liked this post:
psphinx81 (Sep 25, 2016)
Trending Topics
#8
EvoM Guru
iTrader: (1)
Thats where I got the scalings. Id like to help you sort the idle out if you had some time. I only changed the MAP VE scaling. no other things. Give it a shot. LMK, I would suggest setting BISS (if you have it) or adjusting the throttle blade on aftermarket TB, then clocking the sensor back below the suggested % to keep idle stability control active. Thats how I did it with the FB 70mm tb.
https://www.evolutionm.net/forums/ec...-scalings.html
https://www.evolutionm.net/forums/ec...-scalings.html
Last edited by 211Ratsbud; Sep 25, 2016 at 07:12 PM.
Thread
Thread Starter
Forum
Replies
Last Post
psphinx81
Evo Show / Shine
34
Oct 11, 2010 09:41 AM
assembeldbygod
Northeast Region
8
May 14, 2008 08:47 PM