Getting past the 30.1 PSI limit...94170715 ROM
#1
Getting past the 30.1 PSI limit...94170715 ROM
Hi, so I am trying to get around 33-35 PSI on FP RED. Build link is in the sig. In ECUFlash, the load limit sits at 159.7 and PSI at 30.1, can't figure out how to get it past that. 0715 on the 8 ROM. I thought there was a table to adjust that. However, I can't seem to find it. What am I missing?
Thanks in advance.
Thanks in advance.
#5
which load are you logging ?? at 30 psi you should be near 300 2byte load.
look in rom for (set to 9 to remove load limit )
look in rom for (set to 9 to remove load limit )
My load seems low at approx 270 as the highest in a 3rd gear log blowin 29 PSI...
Which table's load/psi limit are you referring to?
#8
different story lol yes eliminator patch
What are the other 3 bits changed too? Does this look right: 0x9000?
Also, has anyone changed the Load scaling from Load 8 to Loadx1 for the Boost Desired Engine Load?
Last edited by Raceghost; Nov 21, 2016 at 11:43 AM.
#9
Evolved Member
iTrader: (10)
You should have a boost adder table that you can use to get around the limits of the BDE tables. The boost the ECU will target is boost adder + BDE, so if you want 10 psi more than what the BDE table allows you to have, just set the boost adder table 10 higher than it currently is, along with the BDE table maxed out.
#10
The boost the ECU will target is boost adder + BDE, so if you want 10 psi more than what the BDE table allows you to have, just set the boost adder table 10 higher than it currently is, along with the BDE table maxed out.
#12
That is the "legit" and only way to do it.
#14
highlight, hit enter type 0x0009 hit enter again
Thanks for the due diligence.
That is the "legit" and only way to do it.