skochur

iTrader: (4)

i did a search and could not come up with any real concrete data... so my question is... if i buy an evo9 block would i be able to use my evo8 head,cams,exhaust manifold, and evo 9 turbo? will this all bolt to my evo8 trans? also if yes then what has to be done to a 9 block to work with an 8 head...thanks in advance....

skochur

iTrader: (4)

ttt...need help with this guys

o7'silvermax

iTrader: (7)

all you need to put an evo 8 head on a 9 block is a fitting for the oil pressure sensor its not hard to find it

94AWDcoupe

iTrader: (125)

all you have to do is block oil feed for mivec on back of block. and extend the wire for low oil pressure sender since the 9 has it mounted on oil pump housing instead of back of block.

skochur

iTrader: (4)

thanks for the help guys... and i assume it would mount to an 8 trans and everything else?

skochur

iTrader: (4)

ttt

TxEvo8

iTrader: (5)

u will probably need an 8 ecu as well

skochur

iTrader: (4)

i have an evo8 ecu as my car is an evo 8...only reason im asking about the 9block with 8 head is that it is hard to find an 8 block with low miles....

skochur

iTrader: (4)

ttt

gsrboi80

iTrader: (38)

Yes the VIII trans and TC will bolt up no worries man

GPTourer

I had thought the evo 9 had some revised water passages. Do these line up with an 8 block and none have to be plugged or altered?

Boomer0822041

i have a complete evo 8 engine in my garage right now. about 60,000 miles on it. it does need work though. idk whats wrong with it