Bored today to I made a ashtray gauge pod
#20
Evolving Member
iTrader: (4)
Honestly sir, if you make two versions of this, the one already seen here and one angled toward the driver appropriately, and available for different size gauges, you would have quite the product. Just based on this thread there is quite a market for it. Imagine if it were marketed.
#21
well I tweaked the design a bit and it fits so much better. No tape or anything is needed its just a tight press in fit. The first pic is looking down from above and the second one is from my point of view in the driver seat. Ignore the dryer sheet in the passenger footwell my car needs to be cleaned but ive been busy lately
I still have to see about selling them. They arent really super smooth when they come off the printer and need a bit of sanding. I have to see how much it takes to get it nice and also see about vendor pricing so I can sell these following the rules.
I still have to see about selling them. They arent really super smooth when they come off the printer and need a bit of sanding. I have to see how much it takes to get it nice and also see about vendor pricing so I can sell these following the rules.