T-Bolt Clamps (How to and list)
Apr 5, 2006, 07:43 AM
#1
Evolved Member
Thread Starter
iTrader: (3)
Join Date: Sep 2003
Location: Lafayette, LA (Da Bayou)
Posts: 1,179
Likes: 0
Received 0 Likes
on
0 Posts
T-Bolt Clamps (How to and list)
Attached is a list and location diagram of the T-bolt Clamps.
Many people have had problems with IC Hoses blowing off under high boost. There are several fixes. This is probably the cheapest and one of the more permanent solution.
How to:
Remove Under tray.
Remove Front Bumper.
Remove Air box Snorkel.
Now you have access to all the clamps.
If you want to do this right remove the rubber hose and slide both clamps over the ends of the hose and re-install. DO NOT OVER TIGHTEN CLAMPS! You will break the bolt.
My suggestion... I installed about half of my clamps with out removing the hose. This kept the "seal" with the piping. Use caution not to kink the clamp if you try this.
Many people have had problems with IC Hoses blowing off under high boost. There are several fixes. This is probably the cheapest and one of the more permanent solution.
How to:
Remove Under tray.
Remove Front Bumper.
Remove Air box Snorkel.
Now you have access to all the clamps.
If you want to do this right remove the rubber hose and slide both clamps over the ends of the hose and re-install. DO NOT OVER TIGHTEN CLAMPS! You will break the bolt.
My suggestion... I installed about half of my clamps with out removing the hose. This kept the "seal" with the piping. Use caution not to kink the clamp if you try this.
Thread
Thread Starter
Forum
Replies
Last Post
FS[West]: Sakura 3" Intake $250 Shipped
IbeBOOSTIN
For Sale - Engine / Drivetrain / Power
1
Nov 2, 2015 07:30 PM
Eric Lyublinsky
Evo Engine / Turbo / Drivetrain
3
Sep 14, 2013 12:26 PM
sabastian458
Evo How To Requests / Questions / Tips
25
May 8, 2013 12:49 PM
