Special Tool for front stop strut nut?
Apr 12, 2004, 01:55 AM
#1
Evolved Member
Thread Starter
iTrader: (3)
Join Date: Aug 2001
Location: Los Angeles, CA
Posts: 1,076
Likes: 0
Received 0 Likes
on
0 Posts
Special Tool for front stop strut nut?
Did anyone use the mitsubishi special tool to install/remove
front top strut nuts? Could anyone tell me what socket size
would I need to move them?
Thanks,
front top strut nuts? Could anyone tell me what socket size
would I need to move them?
Thanks,
Apr 12, 2004, 09:31 AM
#3
Evolving Member
Join Date: Oct 2002
Location: Northern Michigan
Posts: 362
Likes: 0
Received 0 Likes
on
0 Posts
I just used a regular closed-end wrench once the strut was out of the car, and didn't have any problems loosening it.
It might be easier to get the nut loose while the strut is still installed in the car.
It might be easier to get the nut loose while the strut is still installed in the car.
Apr 13, 2004, 06:29 PM
#5
Evolved Member
iTrader: (5)
Join Date: Apr 2003
Location: Kentucky
Posts: 1,296
Likes: 0
Received 0 Likes
on
0 Posts
An impact will spin the nut off without turning the shaft, no problem. You don't even really need a spring compressor either. I have a spring compressor and it stayed in my toolbox when I installed my Tanabe's.
Apr 14, 2004, 07:51 AM
#7
Evolving Member
They say that so you don't over torque the nut. I have an impact that is only about 50bls, within the spec of the evo. I have been using them of years on struts without any trouble. If you like, you can take the nut off with a impact and install using a socket/ratchet. You may install it with a impact turned down low then check it with a torque wrench. It's only 45bls +/- 7lbs.
Hope this helps.
Hope this helps.
Thread
Thread Starter
Forum
Replies
Last Post
TouringBubble
Evo Tires / Wheels / Brakes / Suspension
3
May 5, 2008 01:35 PM
