sideway180sx

iTrader: (4)

does anybody have a vacuum diagram for the tial 44mm wastegate with stock boost solenoid, and also am i placing the fitting in the right place one on the bottom and one on the side?

aronjaskim

The side port of the tial goes to the stock vac hose that has the red tape (the same one that went to stock wg) and the top is vta. The other hose goes to boost source. The hoses are hooked up exactly how they were stock. Also be sure to plug the other two side ports on the tial or it will overboost like crazy. Dont use the watercooling on that thing it is nothing but problems, at least for me it was.

sideway180sx

iTrader: (4)

so the uncolor line goes to a boost source? where would i hook it up to if the turbo does have a fitting to hook up to.

aronjaskim

Yeah use the fitting on the turbo that's perfect.

sideway180sx

iTrader: (4)

The turbo doesnt have a fitting to hook up to where else can I hook up the other line too?

1800bigk

The instruction I have from Tial say any boost source BEFORE the throttle plate.

sideway180sx

iTrader: (4)

so any boost source before the throttle plate is fine i assume?

sideway180sx

iTrader: (4)

i don't see any lines that i can tap into thats before the throttle plate, i wonder if it would be ok to tap into my boost sensor line for the boost source?

Guru

iTrader: (6)

I drill and taped one into the compressor outlet. Took 5 minutes with a drill, tap and rag.

sideway180sx

iTrader: (4)

So tapping into the boost sensor line is not a good idea to do? Where do I get the fitting at?