Sefikh

Hi, I just recently bought a eonon g2104u and it has a built in steering wheel control function but the only problem is I do not know how to connect it to make it work. I found this but on a facebook post but im not sure where the signal wire is on the factory lancer harness.


How to connect the Steering Wheel Control cables?
Our stardard 1 Din/2 Din units with SWC function are using AD conversion SWC method. So firstly please make sure your car uses AD conversion too rather than Can bus. The unit usually has 3 or 4 control cables need to connect:
- A steering wheel control power cable +5 V.
- A black is ground cable.
- One or two data cables 1 or 2.
Please connect to the 3 or 4 wires of vehicle's steering wheel control correspondingly:
SW1(No. 3 wire) to SW1, SWC2(No. 4 wire) to SWC2, GND to the ground.


If anyone could help me out it would be much appreciated!

Sefikh

Anyone????

TizBiksey

Did you ever get this figured out? I also purchased an eonon unit!

Veronica

iTrader: (2)

Try google for the PAC-SWI instructions - they may have more info...