Oil light comes on after oil change
#8
I actually cleaned out the MAF, IAC and the TB which stopped the stalling. I got the oil pressure sensor but can I do that at any time or do I have to dump out the oil that I just changed?
#10
Evolved Member
iTrader: (11)
I would do it at a oil change. I think just a crescent wrench will do the job? It's pretty simple. Unplug the old sensor, unscrew the old sensor, and install the new sensor.Be sure to pull your battery cable to get rid of any check engine codes. Like I said be sure to use some sealant on the thread when installing the new sensor.
Thread
Thread Starter
Forum
Replies
Last Post
wtvlau
Evo X General
7
Jun 16, 2017 02:08 PM
LVSBB6
Evo X Engine Management / Tuning Forums
26
May 8, 2011 05:45 AM
raasfaas
Evo Electrical / Audio / Security
12
Mar 14, 2009 04:12 PM