Fuel door dampener spring
#1
Evolved Member
Thread Starter
Fuel door dampener spring
I was washing my car a while back and getting inside the fuel door when the dampener spring popped out. The diagram in the manual is not very helpful on figuring out how the spring goes back in. Normally I am pretty good with this stuff, but I cannot figure it out.
Would someone be so kind as to remove their fuel door and take a picture of how the spring is installed.
Here are the pictures of what I am referring to.
Would someone be so kind as to remove their fuel door and take a picture of how the spring is installed.
Here are the pictures of what I am referring to.
#4
Evolved Member
Thread Starter
Ok, I feel like a broken record.
BUT, out of over 250 people that have looked at this post; no one can take 5 minutes to remove the fuel door and take a picture? It takes a 10mm socket and approximately a 3-5" extension. Two bolts, that's it...pops right out! Please...anyone??
BUT, out of over 250 people that have looked at this post; no one can take 5 minutes to remove the fuel door and take a picture? It takes a 10mm socket and approximately a 3-5" extension. Two bolts, that's it...pops right out! Please...anyone??
Trending Topics
#8
Evolved Member
Thread Starter
Thanks kaj! I went and got a new one. A whole whopping $3!! Turns out I have a drive belt recall as well. Even though my pullies and drive belt are just fine. I could use a new belt, I have 115,000kms on the car.
Thread
Thread Starter
Forum
Replies
Last Post
shadow_X
Evo Engine / Turbo / Drivetrain
3
Feb 20, 2014 08:45 PM
Compjoc
For Sale/WTB - Engine / Drivetrain / Power
11
Jun 3, 2005 11:30 AM
smokedmustang
Evo Engine / Turbo / Drivetrain
6
May 22, 2005 11:52 PM
boostedwrx
Evo Engine / Turbo / Drivetrain
3
Feb 11, 2005 05:52 PM