What did you do to/for your Outlander Sport (ASX / RVR) today?
#646
So Far I've install , A Dash mat Helps cut the glare from the new piano black trim , a full set of 8 sill / scuff plates , front 35% tint , weather tech inside mount vent visors , Blue under dash lighting hard wired to the dome lights , front and rear mud flaps , gap fillers between the seats and center council .
On order are 10 watt led lights that will be installed into the rear bumper in place of the red reflectors , and the curt class 3 hitch .
On order are 10 watt led lights that will be installed into the rear bumper in place of the red reflectors , and the curt class 3 hitch .
#648
Evolved Member
Got my door sill plates today, but had a few beers, so I'll put them in tomorrow.
They only say "OUTLANDER". To add the "SPORT" would have been another $125.
They only say "OUTLANDER". To add the "SPORT" would have been another $125.
The following users liked this post:
Jconley123 (Jul 29, 2019)
#650
#652
Evolved Member
also a pain when looking for parts, because you have to filter through all the Outlander stuff.
installed the scuff plates, they do look nice. i'll post some pics tomorrow.
#653
2 stage paint correction, sealed the paint. Followed up with a glaze then finally a coat of wax. Debadged the Mitsubishi and outlander sport tonight.
Last edited by haystack; May 24, 2015 at 09:26 PM.
#656
Evolved Member
#657
Upgraded the front speakers using factory bracket.
https://www.evolutionm.net/g/album/3512660
This link is to my photo album about modifying the factory speaker brackets to upgrade to a pair of 6.5" Alpine component speakers. Its easy and the mounting brackets just slide right back in place. Check it out and let me know what you think
This link is to my photo album about modifying the factory speaker brackets to upgrade to a pair of 6.5" Alpine component speakers. Its easy and the mounting brackets just slide right back in place. Check it out and let me know what you think
#660