96530706 f52 96530706 Mitsubishi TDM Lancer Evolution VIII 6MT 2005 mitsukernel SH7052

Value

Enable Valet Mode :+ Enable Auto-Valet on Fresh Ignition :Enable Alternate Maps Master ADC0F=1,AutoICS=2,TPS=3 :Restore ICS State on Ignition :Flash ICS when on Alternate Map :Flash CEL on Knock :+ Drop Boost on High-Knock :Enable Manual ICS Linger :Enable Spray ICS on Knock :Enable No Lift to Shift :Enable RearO2 Simulator :Enable Manifold Absolute Pressure Averaging :Enable WB02 Check AFR Safety :+ Drop Boost on AFR Out of Range :Enable AirFlow Calcs :Enable Launch Maps :

CEL will flash SLOWLY once KnockSum exceeds this value:

CEL will flash QUICKLY once KnockSum exceeds this value:

Load must EXCEED this value before 'CEL on Knock' activates:

Duration CEL continues to flash AFTER the last occurance has stopped:

Maximum RPM allowed when Valet Mode is activated:

Duration TPS must be held at 100% to activate/de-activate Valet Mode:

Duration CEL continues to flash after Valet Mode is activaed/de-activated:

KNOCK SUM must MEET or EXCEED this value to activate 'Spray on Knock':

Load must exceed this value to allow 'Spray on Knock' to activate:

Duration ICS continues to spray AFTER knock goes below 'KnockSUM Required for Spray':

Maximum amount RPM will drop once NLTS is activated:

Throttle position percentage that must be exceeded to activate NLTS:

Vehicle speed must be UNDER this value to allow NLTS to be activated:

LOAD must be UNDER this value for NLTS to be allowed to activate:

Load must exceed this value to allow AFR Safety Monitoring to lower WGDC to 0% (ECU Controlled Boost only):

WBo2 0-5v Input Voltage must exceed this value to lower WGDC to 0% (ECU controlled boost only):

Duration WGDC stays at 0% (and CEL flashes) after MAX AFR Volts return below threshold:

Duration MAX AFR volts must be exceeded before WGDC is switched to 0%:

Duration ICS sprays after MANUAL ICS button is released:

Delay Time before Alt Maps engage once activated:

Alt Maps cannot be activated if LOAD has already exceeded:

To Activate Alt Maps,ADC0F Voltage Input Must Exceed:

To use "Fuel Cut Load x1" = 0x6DDD To use "Fuel Cut Load x2" = 0x4D00 :

FUEL CUT will not engage until the limit has been exceeded for this duration of time:

HiLo

WGDC stays set at 100% until this load value is exceeded:

(Adjustable from 1-10) 1=most frequent WGDC correction intervals, 10=least frequent:

(Adjustable from 1-10) 1= most frequent WGDC correction intervals 10= Least frequent :

Reactivate OnReactivate OffDeactivate OnDeactivate Off

Throttle position must exceed this percentage to activate Launch Maps:

Vehicle speed must be BELOW this value to activate Launch Maps:

NeutDriveNeutDrive

AC OffAC On

SensitivityTiming LimitUntested

Limiter activated when above:Limiter deactivated when below:

Maximum RPM engine can achieve under ANY condtions:

Maximum RPM engine can achieve while the vehicle is STATIONARY:

0x0040 for 2003 or 0x0055 for 2004 or 0x0058 for 2005 USDM - 0x004D for EDM:

b1b2b3b4

Disable rear o2 heater by changing 0x4A0B to 0x0009:

N/AN/AN/AN/ARear O2 Heater CEL EnableN/AN/AN/A

Hex16

2C702C722C742C762C78

Hex16

2D702D722D742D76

Hex16

1032C1032E10330103321033410336103381033A1033C1033E10340103421034410346103481034A

Hex16

3EFA03EFA23EFA43EFA63EFA83EFAA3EFAC3EFAE3EFB03EFB23EFB43EFB63EFB83EFBA3EFBC3EFBE3EFC03EFC23EFC43EFC63EFC83EFCA3EFCC3EFCE3EFD03EFD23EFD43EFD63EFD83EFDA3EFDC3EFDE3EFE03EFE23EFE43EFE63EFE83EFEA3EFEC3EFEE3EFF03EFF2

pause_periodmin_TPSdeltaMax_pulsewidthidle_TPSRangeafter_engine_start_addition

012345678

On TimeOff Time

OnOff

8000400020001000800400200100804020108421

000102030405060708090A0B0C0D0E0F

Stock Setting= 0x4019 Forced PASS Inpection Setting= 0xE000 :

Stock Setting= 0x6AA1 Forced PASS Inspection= 0xEAFF :

Stock Setting= 0xDA57 Forced PASS Inspection= 0xEAFF :Stock Setting= 0x6AA1 Forced PASS Inspection= 0x6AA7 :

EGR systemOxygen heater sensorOxygen sensorA/C system refrigerantSecondary air systemEvaporative systemHeated catalystCatalyst

bit.15bit.14bit.13bit.12bit.11bit.10bit.9bit.8bit.7bit.6bit.5bit.4bit.3bit.2bit.1bit.0

bit.15front o2 sensor heater circuitbit.13bit.12Disable EGR / Enabled Ign Adv (set bit=1)timing knockdown on light acceleration and less than 3000rpmEnable Warmup Ign Retardbit.8Enable High Oct Ign Map Lookup (and many other subroutines)"WG solenoid? Enable Speed Limit Test"bit.5for full time open loop set to 0for immobilizer function disable set to 0bit.2rear o2bit.0

bit.15bit.14bit.13bit.12bit.11bit.10bit.9bit.8bit.7bit.62nd thermo fan tablebit.4bit.3bit.2bit.1Lean Spool (1=enable 0=diasble)

P0443, P0446, P0403, P0243, P0090, P2263P0450, P0451, P0452, P0453 EvapP0441, P0442 Evapbit.12P0031, P0032, P0037, P0038P1400 MAP SensorP0401 EGR TestP0506, P0507 Idle TestP0170 (P0171, P0172)P0134 Front O2P0300; set bit.4 and bit.5 to 0 to disableP0300; set bit.4 and bit.5 to 0 to disableP0132, P0136 O2P0133, P0159P0421 not in FSMbit.0

P0128 CT Below RegP1603 Battery Backupbit.13bit.12P0180 - P0183, P0461, P2066 Fuel Sensorsbit.10bit.9bit.8P0551 PS PressureP0500 Speed Sensbit.5bit.4bit.3P0234, P0243, P2263P0510 not in FSMP1715, P1750, etc

P0140 Rear O2 No ActP0069 MAP vs BaroP0111 IAT CircuitP0554 PS Press SensP1530 A/C1 Switchbit.10bit.9P0830 Clutch Pedal CircuitP0090 Fuel Pressure Circuitbit.6bit.5bit.4bit.3bit.2bit.1bit.0

0123456789ABCDEF

MUT0XMUT1XMUT2XMUT3XMUT4XMUT5XMUT6XMUT7XMUT8XMUT9XMUTAXMUTBXMUTCXMUTDXMUTEXMUTFXMUT10XMUT11XMUT12XMUT13XMUT14XMUT15XMUT16XMUT17XMUT18XMUT19XMUT1AXMUT1BXMUT1CXMUT1DX