I have RWD'd the evo
 

After 9 years of racing my evo for fun I have finaly
decided to get serious.:D
The thought came about when we had a few too many beers and i was
pulling out my engine for its annual inspection.
Upon doing so we found a lot of cracks in the sub frame and chassis from
the years of launching it hard.
So the decision came to tube frame it and turn the engine to north south etc
and go to an all out drag set up.
The specs so far are

Chromemoly chassis
4 link strange full floater rear end
9"braced diff(32X15" tire)
40 spline axles(mark williams)
Liberty gear box with slider clutch etc
the body will be all the original panels
and I have converted it to lhd aswell.

http://www.performanceforums.com/for...8&d=1222154021

This is what happens when you go crazy with a plazma cutter!!

This is at its current stage with some loaner wheels:Dhttp://www.performanceforums.com/for...1&d=1229334944
http://www.performanceforums.com/for...2&d=1229334983

Wow! Good luck.

Question for you, was this your Evo?

http://www.youtube.com/watch?v=VnG_qR10WD0

cool

Looks like she is coming rite along..

When do you hope to have it done and start testing?

finally, that thing is sweet

wow...that thing is sweet...can't wait to see more progress...

That thing is going to be retarded quick. Good luck {thumbup}

f***in' ill!!!!!!!!! :)

Looks like its gonna be a fun car :) cant wait to see it finshed

Very cool! Looking forward to seeing the finished project. :)

Sweet! I have some RWD exhaust manifolds available if you need one. One for the EVO ngine and one for the older 6 bolt engines.

Have you put any thought into a 10.5w tire on the car? I'm not sure where you are from but that could open the possibility for you to run at several different events since the import racing is dead here.

y would you do this to a evo y not get a mirage instead

wow.