aem uego intermittent logging issues
 

Hey guys, Ive been having problems logging aem uego on my car ever since I got it set up. I am having this issue where it will show zero, sometimes it will read if I switch the usb ports between the serial cable and the tactrix, other times it wont read even if I switch the ports until I restart the laptop. Now I know if the wires leading to the serial dongle are too long you can have issues similar to this but that is not the issue. I don't know if this could be an issue but I have subaru related tuning software on my laptop as well, today I was tuning an 08 wrx and could only get the wideband to read if I restarted the laptop and then after tuning some It wouldn't read at all even after restarting the laptop. Could there be a driver issue between the two different tuning softwares(ecu flash, evoscan and romraider)? I don't have another logging cable for the wideband so unfortunately I can't rule out the logging cable itself being at fault. Thanks in advance!

what version is your cable? the openport 2.0 can read the aem serial directly through the 3.5mm jack. thats how i do it and its very reliable.

it is a tactrix 2.0, interesting I have never tried it that way. I will have to look up on how to set that up cause I have been using the rs232 to usb converter cable.

Check your uego wiring.
It is possibly a bad ground. Whenever I had logging problems, it was always related to the wiring. Not the laptop or drivers.

Can you elaborate it a bit more please.