ECUFlash Power Record?
#32
Originally Posted by TTP Engineering
Your MAF honeycomb is about 13 miles from being crushed into oblivion.
It has survived:
* 10 super high hp dyno pulls
* a tough test drive afterwards
* a 12 mile drive to the track with repeated 3rd and 4th gear pulls to test for problems.
* 3 launches with tire warm-ups banging off the rev limiter here and there, twice blowing off the licp. Weather conditions were deplorable with 148 degree track surface temperatures and a high air temp of 109 degrees. In other words, lots of very turbulent conditions where the MAF could have been ripped and torn apart.
* another 12 mile drive home with a more pulls under boost.
And the screen is still in perfect condition...
Last edited by Smogrunner; Jul 18, 2006 at 10:36 PM.
#33
Update to my post above, with pics.
I raced again yesterday with no problems with my maf screen or with ECUFlash. I ran an 11.0 at128mph. Here a re a few pics for anyone that might doubt that the stock maf can survive. All Alfred@Tuning Technologies did was glue it firmly to the housing.
Ecuflash is the greatest thing since sliced bread!
Pics:
MAF
My timeslips: I am car 6381
Blurry slip with maf:
I am starting to believe that if basic and fairly simple precautions are taken, the MAF screen will hold up just fine.
I raced again yesterday with no problems with my maf screen or with ECUFlash. I ran an 11.0 at128mph. Here a re a few pics for anyone that might doubt that the stock maf can survive. All Alfred@Tuning Technologies did was glue it firmly to the housing.
Ecuflash is the greatest thing since sliced bread!
Pics:
MAF
My timeslips: I am car 6381
Blurry slip with maf:
I am starting to believe that if basic and fairly simple precautions are taken, the MAF screen will hold up just fine.
Last edited by Smogrunner; Jul 30, 2006 at 06:52 AM.
#35
Evolving Member
Join Date: Aug 2004
Location: rancho cucamonga
Posts: 430
Likes: 0
Received 0 Likes
on
0 Posts
<----praying that nothing bad happens to the MAF. Since you have put so much time and money into your car, why not just eliminate the MAF so you dont have to worry about it?
Thread
Thread Starter
Forum
Replies
Last Post
AboodsEvo
EvoM New Member / FAQs / EvoM Rules
8
Nov 22, 2010 07:34 PM