"hanging RPM's" and ISCV maps
#1
Evolving Member
Thread Starter
Join Date: Nov 2005
Location: Morgantown, WV
Posts: 350
Likes: 0
Received 0 Likes
on
0 Posts
"hanging RPM's" and ISCV maps
In regards to the point Malibu Jack made about the "hanging" rpms in post 04 Evo's, and the ISCV maping....
This is a 2003/2004 ISCV map...
This is a 2005 Evo ISCV map (06 IX is the same as 05).....
Sorry to start a new thread, but the other was closed.
Girlie
This is a 2003/2004 ISCV map...
This is a 2005 Evo ISCV map (06 IX is the same as 05).....
Sorry to start a new thread, but the other was closed.
Girlie
#5
Evolving Member
Thread Starter
Join Date: Nov 2005
Location: Morgantown, WV
Posts: 350
Likes: 0
Received 0 Likes
on
0 Posts
Originally Posted by JohnBradley
Have you cross polinated them yet to see if the hanging rpm over rev goes away?
Girlie
#6
Evolving Member
Join Date: Jul 2005
Location: Grand Rapids, MI
Posts: 203
Likes: 0
Received 0 Likes
on
0 Posts
So what do these ISCV maps do exactly and how would it relate to "hanging revs?" It looks like these tables only relate to very low RPMS. Isn't the hanging revs problem related to the way the Ecu holds open the idle-air control valve after abruptly getting off the throttle? It's probably attempting to not spew a bunch of unburned fuel out of the exhaust.
While I'm at it, does anyone know what all the IC Relay stuff is under "Misc?" Does IC mean Inter-Cooler, or Idle-Control or something else?
While I'm at it, does anyone know what all the IC Relay stuff is under "Misc?" Does IC mean Inter-Cooler, or Idle-Control or something else?
Trending Topics
#9
Evolving Member
Thread Starter
Join Date: Nov 2005
Location: Morgantown, WV
Posts: 350
Likes: 0
Received 0 Likes
on
0 Posts
Originally Posted by Ludikraut
Girlie, do you run higher-than-stock idle RPM targets?
l8r)
l8r)
No, they should be stock. "I" never changed them.
Girlie
#10
Evolved Member
iTrader: (20)
Join Date: Apr 2005
Location: Chantilly,VA
Posts: 920
Likes: 0
Received 0 Likes
on
0 Posts
that is not where you control the haning RPM.
change the "desired ISCV initial step position with AC ......" tables.
I changed mine somewhat similiar to 03 setting. it works well.
for example:
"desired ISCV initial step position with AC off drive" engine temp = 77 -> 30
change the "desired ISCV initial step position with AC ......" tables.
I changed mine somewhat similiar to 03 setting. it works well.
for example:
"desired ISCV initial step position with AC off drive" engine temp = 77 -> 30
Thread
Thread Starter
Forum
Replies
Last Post