Lean Spool Trailing Time
May 25, 2014, 01:14 AM
#31
Evolved Member
iTrader: (7)
Join Date: May 2010
Location: Maine
Posts: 836
Likes: 0
Received 0 Likes
on
0 Posts
Ive disabled LS again due to other issues cropping up, Once I get my HG swapped and retune for cams, I plan to do some more testing soon. I still seem to be getting odd intermittent closed loop rich conditions, so it may not have been related to LS.
Quick question
Does the ECU reference the "Rich to Lean" (Rich decay) table when you 1st stab it? Or the "Lean to Rich" (Lean Decay)?
Quick question
Does the ECU reference the "Rich to Lean" (Rich decay) table when you 1st stab it? Or the "Lean to Rich" (Lean Decay)?
May 25, 2014, 02:33 AM
#32
Evolved Member
Once LS is triggered by the load exceeding the threshold, the Lean to Rich table is in operation and the interpolater is increasing.
The Rich to Lean table is in operation when the load falls below the threshold, and thus the interpolator is reduced.
The Rich to Lean table is in operation when the load falls below the threshold, and thus the interpolator is reduced.
Thread
Thread Starter
Forum
Replies
Last Post
EvocentriK
ECU Flash
4
Jan 22, 2012 03:33 PM
