evoscan 2.1 problems and fixes
#98
Newbie
iTrader: (3)
Join Date: May 2008
Location: NW suburbs
Posts: 88
Likes: 0
Received 0 Likes
on
0 Posts
i am getting an access denied message for COM port 1 when i try and connect the EFI portion in EVOscan. i can connect to OBDII and a few of the other ones but the readings are off and none of the gauges in the software work.
i know someone else earlier in this thread had a similar problem but i have the same message for a different reason. i am not sure if it is an EVOscan issue or an issue with the way things are set up on my computer.
at first by default my computer installed the link cable to COM7 so i changed it over to COM1 made sure everything in EVOscan was on COM1.
i pulled my maps just fine with ECUflash so i know there is nothing wrong with my link cable. and yes ECUflash was closed when i tried to connect via EVOscan.
there is a definite possibility that this is a newb mistake with a setting somewhere. i have searched for threads about setting up EVOscan but have not found any. if someone could point me in the right direction it would be appreciated.
i know someone else earlier in this thread had a similar problem but i have the same message for a different reason. i am not sure if it is an EVOscan issue or an issue with the way things are set up on my computer.
at first by default my computer installed the link cable to COM7 so i changed it over to COM1 made sure everything in EVOscan was on COM1.
i pulled my maps just fine with ECUflash so i know there is nothing wrong with my link cable. and yes ECUflash was closed when i tried to connect via EVOscan.
there is a definite possibility that this is a newb mistake with a setting somewhere. i have searched for threads about setting up EVOscan but have not found any. if someone could point me in the right direction it would be appreciated.
#99
Newbie
iTrader: (9)
Join Date: Jan 2007
Location: WVC, UT
Posts: 85
Likes: 0
Received 0 Likes
on
0 Posts
For the formulas, this is what it says:
Is that right? The fuel trim low formula just says "x". Is the rest of it right too? (Specifically the STFT?)
Thanks
#102
im getting this on my 04 sti and im using windows 7 starter
Info: Initialize Vehicle ECU...
Info: Initializing At 5 baud...
Info: Initialization Complete...
Info: Waiting for INIT Response...
Info: ECU ID: E4C7
Info: Connection successful...
Error: Index was outside the bounds of the array.
Info: Datalogger Ended
Info: Initialize Vehicle ECU...
Info: Initializing At 5 baud...
Info: Initialization Complete...
Info: Waiting for INIT Response...
Info: ECU ID: E4C7
Info: Connection successful...
Error: Index was outside the bounds of the array.
Info: Datalogger Ended
Thread
Thread Starter
Forum
Replies
Last Post