Detailed mapping of Periphery bits underway
#33
Someone needs to look at the ECU wiring diagram in the EDM Evo 9 factory service manual. If someone can report back the pin number, I can report back the ADC input and associated RAM addresses to log.
Since EDM Evos also lack manifold air temp measurement, my guess is that the ADC input 0E is used for tranny temp on EDM cars. This is the same ADC input that is used for fuel temp on USDM cars.
Since EDM Evos also lack manifold air temp measurement, my guess is that the ADC input 0E is used for tranny temp on EDM cars. This is the same ADC input that is used for fuel temp on USDM cars.
#36
#38
#40
Sometime in the next month or so, I hope to take all the recent finds and get them into an updated set of xmls for the next release of ECUFlash. Probably close to a month away though as I'll be spending my near term time doing some maintenance and adding some new components to my Evo.
#43
Evolved Member
iTrader: (30)
Join Date: Oct 2006
Location: Fl/Jam
Posts: 780
Likes: 0
Received 0 Likes
on
0 Posts
Can the periphery tables be added to V1.29a? I have the tactrix 1.3 cable but it doesn't seem to work with any other version of ecuflash thank 1.29. I was told that there is a software update that I need to do but I've been emailing tactrix for about a week now with no response.
I know the tables were added to v1.35 and higher, but is it backwards compatible?
I know the tables were added to v1.35 and higher, but is it backwards compatible?
#44
The original Periphery tables work with v1.29, but the newer Periphery Bit tables do not work. If you bought the cable from Tactrix, I suggest calling Tactrix. Make sure you have a copy of the sales receipt in-hand, or else you'll get no assistance with updating your cable because without one, they'll assume that you have a pirated cable. Contact Limitless if you bought the cable from them.
#45
Evolved Member
iTrader: (30)
Join Date: Oct 2006
Location: Fl/Jam
Posts: 780
Likes: 0
Received 0 Likes
on
0 Posts
I got the cable from tactrix but it was so long ago I don't even know where to begin to look for that receipt...I'm going to give them a call anyway and try my luck. In the event that they choose not to help me, mrfred could you point me to the older periphery tables...I've searched and only came up with the new ones. Right now I pretty much need them to disable my lean spool (the better way), disable my EGR for the JDM Map patch, etc.
Thanks for the help.
Worst case is I'll just have to go buy one of the 2.0 cables which I really dont want to have to do.
Thanks for the help.
Worst case is I'll just have to go buy one of the 2.0 cables which I really dont want to have to do.