disabling lean spool
#61
Evolved Member
Regardless of what rpm value you load into the Lean Spool start and stop rpm parameters, the code loop is still active and some degree of correction is likely to occur below the start rpm due to one of the 1D parameters still being active.
So the correct method of disabling the function completely is via the bit flag in the options/periphery section.
So the correct method of disabling the function completely is via the bit flag in the options/periphery section.
Last edited by merlin.oz; Sep 23, 2017 at 03:03 PM.
The following users liked this post:
ChainedSoul (Mar 5, 2019)
Thread
Thread Starter
Forum
Replies
Last Post
stealthMR
Toronto Lancer Club
31
Sep 27, 2017 07:38 PM
3011carlos
Evo X Engine Management / Tuning Forums
4
Jun 9, 2017 07:20 PM