EvoScan v2.6 B16 Logging Problems with Zeitronix ZT2
#1
EvoScan v2.6 B16 Logging Problems with Zeitronix ZT2
Hello all,
I just installed my wideband today and when I try to log with EvoScan the readings are all over the place, jumping up and down all the time. If I disconnect and unplug the USB to Serial adapter for the Zeitronix unit everything reads fine within EvoScan. The Zeitronix software works fine and if I use Mitsulogger 2.0 beta I can log everything fine. Just appears to be a problem with EvoScan. Any ideas?
Dan
*Update*
It was my USB-Serial Hardware, went with Belkin from Staples and have had no issues.
I just installed my wideband today and when I try to log with EvoScan the readings are all over the place, jumping up and down all the time. If I disconnect and unplug the USB to Serial adapter for the Zeitronix unit everything reads fine within EvoScan. The Zeitronix software works fine and if I use Mitsulogger 2.0 beta I can log everything fine. Just appears to be a problem with EvoScan. Any ideas?
Dan
*Update*
It was my USB-Serial Hardware, went with Belkin from Staples and have had no issues.
Last edited by rawkus; Aug 19, 2009 at 12:23 PM. Reason: Figured out the problem
#4
I have the same problem with mine sometimes, i reboot my laptop and it works. To avoid this bug i plug the usb cable when the system is started, . I think i have a conflict between my touch pad driver and usb to serial adapter driver.
#7
Evolving Member
iTrader: (8)
The zeitronix software works fine for me and logs AFR but EvoScan 2.6 isn't logging AFR for me. I set it to com port 1 which is the same port the zeitronix software uses but its not logging. My laptop has a serial port so I'm using that. Do I have to get a serial to USB adapter for evoscan to log properly?
Trending Topics
#8
Did you check the necessary 'External Wideband A/F Ratio' field (from the 'Items to Data Log' pane on the left hand side) as well as all the desired/relevant 'ZTX xxx' fields (in addition to selecting 'Zeitronix ZT2' from the 'Wideband (WDB)' drop-down menu)?
#11
Evolved Member
iTrader: (1)
Zeitronix software works, Evoscan shows 0 for the value. Evoscan worked the first time, but threw a fit ever since. Rebooted, removed driver, reinstalled driver, etc. Randomly it works but refuses to work after I stop logging during that session.
I'm going to try a different Serial->USB adapter. Currently using a TrendNet adapter found at microcenter for $15.
I'll try to follow the post by Rawkus and grab a Belkin from Staples after seeing that it fixed his issue. I'd prefer not to wire into the ECU but it if keeps refusing to log then I might have to.
Last edited by acidtonic; Nov 3, 2011 at 10:54 AM.
Thread
Thread Starter
Forum
Replies
Last Post
stefenboy
For Sale - Interior / Exterior / Sound / Styling
0
May 20, 2016 07:51 PM
Dimmoun
ECU Flash
0
Apr 19, 2016 12:20 AM
Danner
General Engine Management / Tuning Forum
5
Aug 13, 2011 11:13 AM