VegasVIII

has anyone attempted to try on rom 92290022? have a 2004 oz thats a pain in the butt

McLaren F1 2003

iTrader: (8)

Does anyone know why this is going on? Attached are my Ecuflash settings and the way my car reads in Scantech. It only shows 3 sensors as ready. Is that right? Even when I set everything to pass, it only shows those 3 sensors.

Thanks in advance!

McLaren F1 2003

iTrader: (8)

Anyone?

MrSquirr3l

iTrader: (13)

have these been done for rom 96530706?

Broke4speed

Have you looked? They're standard on the Tephra V7 rom you're referring to...

KrakHed

I've tried the existing settings of:

part 1 : E000
part 2 : EAFF
Comp : EAFF and 6AA7

But when I take it to get inspected, the following monitors show up as unsupported:

O2 sensor
Catalytic
egr flow
EVAP

I've tried several other settings and the closest I've gotten is:

part 2: 6AE5
comp: DAE5 and 6AA1

These get the other monitors working again, except EGR. Anyone know how to get the EGR flow monitor working again? All of my emissions equipment is currently installed.
Thanks in advance.

EDIT:
I believe I found where it's turned on. In the FCA #9 from the ECU periphery. Setting this to 1 brought the EGR test back up. Thought I'd post it here in case anyone else had the same issue.

StreakGSX

iTrader: (1)

Has anyone had any issues passing inspection with setting everything to pass? Also how many miles do I need to drive after I do this or does this eliminate the need to drive the car x amount of miles?

l2r99gst

iTrader: (2)

Best thing to do is set the monitors as how they are stock. Don't set everything to available and everything to pass.

As far as driving, you don't have to, it will show as passed immediately (the one downside to this patch).

StreakGSX

iTrader: (1)

What should I change then? I need to get inspected tomorrow Hopefully it works. I'll read more and see what I should do.

Thanks!

StreakGSX

iTrader: (1)

Also, To get rid of the CEL light can I just change the periphery0(FAA) rear02 (bit1) to 0 and periphery(FCA) p0421(Bit1) to 0 to eliminate the CEL light so I can pass inspection tomorrow!! Please help !

3gturbo

iTrader: (4)

If you take the time to read this thread you can do it yourself.

Werdna06

iTrader: (1)

so i copied and pasted this patch on 88590015 and when i click on Non-continuous monitor completion patch check box ecu flash just closes. it doesn't allow me to change values. is this an issue with ecu flash software version?

lynex

anyone know how to get to the tutorial video in the first post? the link is not working for me

rome831

Does any body know which monitors are suppose to say not supported from the factory? I bought my car already tuned and all the monitors say pass. My car does not pass emissions because of this.

killerpenguin21

iTrader: (20)

try this

https://www.evolutionm.net/forums/9605729-post226.html