maximusnz

Hey everyone I'm new on this forum,

I've just received my 1.3 cable and I'm wanting to reflash my ecu. I've noticed that my evo 5 doesn't have the white connector for the reflash plug that is attached with the cable.

Is it possible to connect that wire to pin 79 so I can reflash my evo 7 ecu.

Thanks

Max

evonut270

the 5 does have a flash connector. but yes if your struggling you can connect the wire to pin 79

maximusnz

I checked and there isnt a flash connector

evonut270

it will be hiding in the loom near the obd port.iv had problems finding them before.

maximusnz

sweet as, ill have another look, thanks for the reply

Mellon Racing

iTrader: (38)

which mas are you going to use with your 5?

maximusnz

I'm going to reflash my evo 7 ecu with a evo 7 ralliart rom

Mellon Racing

iTrader: (38)

so you're keeping the stock evo 5 mas and going to flash the evo 7 ralliart ROM on the car???

evonut270

there is very little between the 5 maf and 7 maf in terms of size and scaling.

maximusnz

if I have to change the maf then I would no problems

Mellon Racing

iTrader: (38)

if they aren't exactly the same that wouldn't be acceptable to me and I sure wouldn't throw a RalliArt tune from a 7 on it to make matters worse and call it good

evonut270

you dont have to change the maf.just change the scalings + size

maximusnz

cheers everyone

evonut270

me either which is why the scaings should be changed.but the stock scalings will be enough to get it fired up.theres been plenty done with this conversion with no probs

Mellon Racing

iTrader: (38)

NOW you're following my questioning of the OP's decision