GT30R - question about boost control
#16
Former Sponsor
iTrader: (12)
Hey again. I've tested today my Grimmspeed BCS with GT30R and Tial External Wastegate with 1 bar spring.
I was set my baseline boost, BEC and baseline WGDC to zero, because I wanted try will it works.
Boost is spoolin really smooth and not agressive, holds 1 bar (that WG spring says) until about 6000 rpm, and then is gettin up to about 1.2 bar.
What am I doing wrong? Or maybe it is normally?
I was set my baseline boost, BEC and baseline WGDC to zero, because I wanted try will it works.
Boost is spoolin really smooth and not agressive, holds 1 bar (that WG spring says) until about 6000 rpm, and then is gettin up to about 1.2 bar.
What am I doing wrong? Or maybe it is normally?
Last edited by Boosted Tuning; Dec 19, 2010 at 11:54 PM. Reason: grammer
#17
Evolving Member
Thread Starter
Thanks. I think You might be right. I don't need that lil boost, so I will try to set some higher and then will report back. The problem is that we have a lot snow in Poland now, so I must go to the dyno cause testing on the road is a lil dangerous now haha
Thread
Thread Starter
Forum
Replies
Last Post
Mines Evo IX
Evo Engine / Turbo / Drivetrain
3
Sep 2, 2007 11:04 PM
EFIxMR
Evo Engine / Turbo / Drivetrain
4
Jul 26, 2006 03:24 PM