evoscan works fine but can't connect to ecuflash
#1
Newbie
Thread Starter
iTrader: (8)
Join Date: Dec 2010
Location: RI
Posts: 75
Likes: 0
Received 0 Likes
on
0 Posts
evoscan works fine but can't connect to ecuflash
I have an 06 EVO IX MR with the openport 1.3U cable. Evoscan 2.8 works fine but I can't connect at all to EcuFlash 1.42. I get a "no response to any known code" error. Do I need a different version of the program?
#4
Newbie
Thread Starter
iTrader: (8)
Join Date: Dec 2010
Location: RI
Posts: 75
Likes: 0
Received 0 Likes
on
0 Posts
ok I drove the car around and let it run for a bit and this is the new error i'm getting:
[18:10:04.769] Using interface OpenPort 1.3 Universal TX2CsVnW9dc6e4cd3932aa0ca6651b85013b28b522b076b5
[18:10:06.688] sending init sequence 1 (0001)
[18:10:07.733] got 0x05 response
[18:10:07.733] sending init sequence 2
[18:10:07.733] got 0x1B response
[18:10:07.733] sending init sequence 3
[18:10:08.123] entering bootloader
[18:10:08.123] sending kernel size (0)
[18:10:08.139] sending kernel load address (0xFFFF6000)
[18:10:08.139] error sending kernel load address
[18:10:08.154] interface close
on my defi gauge it said I was over 12 volts while trying to connect
[18:10:04.769] Using interface OpenPort 1.3 Universal TX2CsVnW9dc6e4cd3932aa0ca6651b85013b28b522b076b5
[18:10:06.688] sending init sequence 1 (0001)
[18:10:07.733] got 0x05 response
[18:10:07.733] sending init sequence 2
[18:10:07.733] got 0x1B response
[18:10:07.733] sending init sequence 3
[18:10:08.123] entering bootloader
[18:10:08.123] sending kernel size (0)
[18:10:08.139] sending kernel load address (0xFFFF6000)
[18:10:08.139] error sending kernel load address
[18:10:08.154] interface close
on my defi gauge it said I was over 12 volts while trying to connect
Thread
Thread Starter
Forum
Replies
Last Post