Why is my 1 byte load so high compared to baro+temp compensated 2byte load?
#1
Why is my 1 byte load so high compared to baro+temp compensated 2byte load?
So I switched back to E85 and went to do some tuning today and I am hitting up to 441 1byte load, same cell is 382 2byte baro+temp compensated... that is 60 kpa load off, making it hard when it comes time to remember which one to use for fuel or timing... also I have my 1byte load factor at 1.8 to see where im at..
Here is the log...
Here is the log...
#4
EvoM Guru
iTrader: (6)
I should have said, B+T was exactly like R... until you got to full boost
and then the more you stayed in it the more it deviated..
I am guessing this is becuase of the design of the Baro sensor on CT9A, being in the induction pipe its not a REAL baro reading, since when your on boost its reading a vacuum....
Unless you do the airbox mod to free up the restriction
and then the more you stayed in it the more it deviated..
I am guessing this is becuase of the design of the Baro sensor on CT9A, being in the induction pipe its not a REAL baro reading, since when your on boost its reading a vacuum....
Unless you do the airbox mod to free up the restriction
Thread
Thread Starter
Forum
Replies
Last Post