How to get car to start on new pcm, without immobilizer code?
#1
Evolved Member
Thread Starter
iTrader: (42)
Join Date: Jul 2008
Location: East Coast
Posts: 924
Likes: 0
Received 0 Likes
on
0 Posts
How to get car to start on new pcm, without immobilizer code?
Long story short, the car I bought came AEM, and we switched it over back to stock PCM, MAF controlled. The car didn't come with the stock PCM though, so we just used one that was laying around the shop. The problem is, that car's immobilizer code is not known, since it didn't come with the stock PCM, or the stock immobilizer code written down.
What steps should I take next, to get the car to start up? Is it as easy as going into EcuFlash, and changing the hex code to disable the immobilizer, or will I need to have a dealer flash it?
Thanks!
--mark
What steps should I take next, to get the car to start up? Is it as easy as going into EcuFlash, and changing the hex code to disable the immobilizer, or will I need to have a dealer flash it?
Thanks!
--mark
Thread
Thread Starter
Forum
Replies
Last Post
mady4g63
General Engine Management / Tuning Forum
0
Nov 27, 2014 12:38 AM
black_out
General Engine Management / Tuning Forum
1
May 6, 2014 12:09 PM
impreza2darksyd
General Engine Management / Tuning Forum
9
Feb 12, 2007 07:51 PM