TephraMod V7 & Omni 4 Bar MAP Sensor - Can't Log Boost - Help
#16
Newbie
iTrader: (4)
Join Date: May 2011
Location: Philly
Posts: 63
Likes: 0
Received 0 Likes
on
0 Posts
did you dl the right v7 with omni maps? if not it won't come preconfiged for omni map sensor. this is the correct one you're looking for http://www.norcalmotorsports.org/use...phenem-fix.zip
#17
did you dl the right v7 with omni maps? if not it won't come preconfiged for omni map sensor. this is the correct one you're looking for http://www.norcalmotorsports.org/use...phenem-fix.zip
Yes I'm pretty sure that my tuner gave me thew right V7. He has tuned many EVO's using v7.
#19
Evolving Member
iTrader: (3)
If I understand you right your sensor gives signal of 0.02V without power applied to it and 4.4V if powered by standard 5V.
With 5V applied and in atmospheric conditions your sensor yellow wire should give you value a bit lower than 1.168V. From what you reported above you get 4.4V (close to the max voltage the sensor can produce) in such conditions - hence it is most likely that the sensor is broken. Another option is broken harness or connector. I'd first check the harness and connector and if everything fine there, try to do the same exercise with another sensor. Just don't attempt it vice versa as if you have broken connector you can possibly damage any sensor you connect it to.
With 5V applied and in atmospheric conditions your sensor yellow wire should give you value a bit lower than 1.168V. From what you reported above you get 4.4V (close to the max voltage the sensor can produce) in such conditions - hence it is most likely that the sensor is broken. Another option is broken harness or connector. I'd first check the harness and connector and if everything fine there, try to do the same exercise with another sensor. Just don't attempt it vice versa as if you have broken connector you can possibly damage any sensor you connect it to.
Voltage at connector/MAP Sensor end - measured at connector to Map Sensor:
Yellow Wire - Manifold Differential Pressure Sensor - Pin #73 - voltage = .02
Black Wire - Sensor Ground - Pin #92 - voltage = .019
Grey Wire - Power +5volts - Pin #81 - voltage = 5
With 5 volts applied to the sensor (pin #81) the yellow wire coming from the sensor reads 4.4 volts
so what's that tell me?
Yellow Wire - Manifold Differential Pressure Sensor - Pin #73 - voltage = .02
Black Wire - Sensor Ground - Pin #92 - voltage = .019
Grey Wire - Power +5volts - Pin #81 - voltage = 5
With 5 volts applied to the sensor (pin #81) the yellow wire coming from the sensor reads 4.4 volts
so what's that tell me?
Thread
Thread Starter
Forum
Replies
Last Post
Bewstzalot
General Engine Management / Tuning Forum
4
Jul 7, 2017 01:35 PM