iziegsx

iTrader: (3)

Hey all,

I own a 2003 JDM evo8 and as some of you know the map sensor for the USDM evo8 is on the intake manifold. I have switched over to a Buschur racing ported intake manifold. The map sensor does not have a connector switch and so it is just there (not connected to anything) Could any of you have give me some insight as to what i should. I was hoping to hook up an omni 4 bar and grimmspeed 3port.

Looking forward to some feedback.

chetrickerman

iTrader: (7)

are you looking for the connector or the MAP sensor?

iziegsx

iTrader: (3)

What ever i need to successfully install the omni 4bar. Would be nice to find both though even if i do not need to. Wish i had a FSM for this car!

chetrickerman

iTrader: (7)

check out this thread

https://www.evolutionm.net/forums/ec...plug-play.html

there are a lot of threads on this in this section

iziegsx

iTrader: (3)

Thanks alot man. Im going to check your link and also i found the pin out for my ecu so tomorrow i will check pin 92 and see if it has any wires. Must send a shout out to 4WS tuning for the tech support!

chetrickerman

iTrader: (7)

happy to help you out

iziegsx

iTrader: (3)

For all JDM evo8 owners. Note your car does not have a map sensor. The JDM evo9's however possess one. Attached is the JDM evo 8 ecu pin out.