Speed density - Using IAT WGDC correction table
#1
Speed density - Using IAT WGDC correction table
From all the reading I've done, I suppose that the MAF IAT WGDC Correction table wouldn't work anymore when switching to a SD patched V7.
That's what is keeping me from going to speed density, I need this correction because I live in a region where temps go from -10f to +90f...
Is there any way to get the fuel temp sensor used for V7SD to work with the MAF IAT WGDC Correction map. I suppose there is an adress to change in the MUT tables but I'm still not a ecuflash guru
Suggestions?
That's what is keeping me from going to speed density, I need this correction because I live in a region where temps go from -10f to +90f...
Is there any way to get the fuel temp sensor used for V7SD to work with the MAF IAT WGDC Correction map. I suppose there is an adress to change in the MUT tables but I'm still not a ecuflash guru
Suggestions?
Thread
Thread Starter
Forum
Replies
Last Post
hkumar
Evo X Engine Management / Tuning Forums
11
Sep 9, 2013 07:55 PM