Need help with Injector Scaling
#1
Evolving Member
Thread Starter
iTrader: (10)
Join Date: Nov 2006
Location: Midwest (In EvoM, its SW lol)
Posts: 292
Likes: 0
Received 1 Like
on
1 Post
Need help with Injector Scaling
So, I installed FIC 1050 and used Schiedes' numbers:
FIC 1050s
Scaling: 1008
Latencies:
Volts ms
4.69 4.440
7.03 3.192
9.38 1.752
11.72 1.032
14.06 0.840
16.41 0.576
18.68 0.432
After cruising, my LTFT Mids was -1.95 while LTFT Lows 6.25. I lowered the scaling and the exact opposite happened with Mids decreasing to like -7ish, but lows decrease to like 1ish to 0.xx. So, I set it back to 1008 again. Per the big "Injector Scaling and Latency" thread, I should decrease 11.72V which would lower LTFT Lows, but not effect mids?
FIC 1050s
Scaling: 1008
Latencies:
Volts ms
4.69 4.440
7.03 3.192
9.38 1.752
11.72 1.032
14.06 0.840
16.41 0.576
18.68 0.432
After cruising, my LTFT Mids was -1.95 while LTFT Lows 6.25. I lowered the scaling and the exact opposite happened with Mids decreasing to like -7ish, but lows decrease to like 1ish to 0.xx. So, I set it back to 1008 again. Per the big "Injector Scaling and Latency" thread, I should decrease 11.72V which would lower LTFT Lows, but not effect mids?
#6
Evolving Member
Thread Starter
iTrader: (10)
Join Date: Nov 2006
Location: Midwest (In EvoM, its SW lol)
Posts: 292
Likes: 0
Received 1 Like
on
1 Post
How important is it to get to 0? What does this affect? Right now, my best % are low=3-5% within 30 mins (goes back/forth) and mids=-2 to -4.5% (goes back/forth) within 24 mins. Everytime I tried different setting, it breaks the 5% range to like 7 or 8. I'm using 1008 for scaling. When I change scaling, one trim would be good the other would be wayy off.
Thread
Thread Starter
Forum
Replies
Last Post
ecktt
General Engine Management / Tuning Forum
4
May 8, 2017 06:18 PM
Raceghost
ECU Flash
22
Jun 1, 2016 12:30 AM