Unknown new rom ID 52370028
#1
Evolving Member
Thread Starter
Unknown new rom ID 52370028
Has anyone seen this rom id or similar before? If I use 52370023 or 52370024 (2008 JDM SST) xml, the LOAD and RPM scaling is wrong.
I will try and flash older rom id above is everything else failed.
Thanks for your help!
I will try and flash older rom id above is everything else failed.
Thanks for your help!
#2
Evolving Member
Hi,
It seems that the tables of your rom ( 52370028 ) need to be re-defined entirely.
I corrected tables within just timing section. If you need more tables, I can help you but need time to read the codes.
It seems that the tables of your rom ( 52370028 ) need to be re-defined entirely.
I corrected tables within just timing section. If you need more tables, I can help you but need time to read the codes.
#3
Evolving Member
Thread Starter
Thank you so much! I can't believe this rom is entirely different than previous romid. Sigh..
#6
Evolving Member
Please feel easy. Helping each other is a good point of the community.
I got some time to add fuel section for the xml. ( Cylinder Fuel trim 1-4, Low Octane Fuel Map has not done yet. )
I got some time to add fuel section for the xml. ( Cylinder Fuel trim 1-4, Low Octane Fuel Map has not done yet. )
Last edited by crimson red; Jul 12, 2013 at 05:39 AM.
#7
Hi,
I'm also looking for 53590008 ROM xml fro JDM Ralliart SST. I tried to use JDM Evo X SST xml but it's all wrong. Can anyone tell if it is interchangable with any other ROMs?
I'm also looking for 53590008 ROM xml fro JDM Ralliart SST. I tried to use JDM Evo X SST xml but it's all wrong. Can anyone tell if it is interchangable with any other ROMs?
Trending Topics
The following users liked this post:
shayeight (Feb 4, 2019)
#10
The following users liked this post:
shayeight (Feb 4, 2019)
#14
Evolving Member
Attached is the 52370028 definition fully ported from 52370024(Golden's definition).
However, there's a point to pay attention to.
In the definition of Golden 's 52370024, since the following tables refer to the same addresses, they should be incorrect of either table(Using tables in the SST categories, be careful.):
1. "Airflow Check Offset" and "SST Throttle Requested Torque Subtractor Map"
2. "Torque Limiter # 1" and "SST Torque Map # 1 - Error (unknown)"
3. "Torque Limiter # 3" and "SST Torque Map # 2 - Cold / Interpolated (unknown)"
4. "Torque Limiter # 2" and "SST Torque Map # 3 - Hot / Interpolated (unknown)"
5. "Torque Limiter # 4" and "SST Torque Map # 4 - Unknown"
6. "SST Clutch Pressure RampUp - Adjust Offset 2D:" and "SST Torque Limit Reduction Table by RPM (CPRU_A)"
The following users liked this post:
shayeight (Feb 4, 2019)
Thread
Thread Starter
Forum
Replies
Last Post