ECU thinks I have a MAF again...
#1
ECU thinks I have a MAF again...
But I'm on SD...
So I was in EcuFlash today, felt like getting my Cosworth M3's to lope again. Adjusted the MIVEC numbers at idle, pressed "write to ECU", no biggie...I've been through this a million times. Halfway through the write, I got an error (forget what it said) and it said to press the "write to ECU" button again to finish writing the map. Well I did and it went fine.
However, I went to drive the car a little later and it ran like utter crap. Pulled the codes and I got a P0113, P0102, and a P2228...all of which I believe are MAF related. So I'm guessing the car is in some kind of limp mode right now because it's not getting any signal from the MAF, because there is no MAF.
So my question is, how do I get the ECU back to the way it was? I'm not a tuning guru so I'm not sure how SD exactly works, whether it disables the MAF or tricks it into thinking there's one or whatever...I don't know.
How do I disable the MAF and/or get the ECU to think the MAF is still there?
Thanks in advance!
EDIT: My rom is 88590015 if that helps any...I'm gonna need a step by step process because I'm clueless when it comes to tuning Evos. I can rip the motor apart and put it back together but tuning is beyond me.
So I was in EcuFlash today, felt like getting my Cosworth M3's to lope again. Adjusted the MIVEC numbers at idle, pressed "write to ECU", no biggie...I've been through this a million times. Halfway through the write, I got an error (forget what it said) and it said to press the "write to ECU" button again to finish writing the map. Well I did and it went fine.
However, I went to drive the car a little later and it ran like utter crap. Pulled the codes and I got a P0113, P0102, and a P2228...all of which I believe are MAF related. So I'm guessing the car is in some kind of limp mode right now because it's not getting any signal from the MAF, because there is no MAF.
So my question is, how do I get the ECU back to the way it was? I'm not a tuning guru so I'm not sure how SD exactly works, whether it disables the MAF or tricks it into thinking there's one or whatever...I don't know.
How do I disable the MAF and/or get the ECU to think the MAF is still there?
Thanks in advance!
EDIT: My rom is 88590015 if that helps any...I'm gonna need a step by step process because I'm clueless when it comes to tuning Evos. I can rip the motor apart and put it back together but tuning is beyond me.
Last edited by Babs; Nov 12, 2013 at 09:05 PM.
Thread
Thread Starter
Forum
Replies
Last Post
senate6268
Lancer Engine Management / Tuning Forums
91
Dec 26, 2022 12:20 AM
scheides
ECU Flash
357
Oct 22, 2021 08:59 AM
NZEvox
Evo X Engine Management / Tuning Forums
2
Feb 10, 2013 01:40 AM
Live4Redline
Lancer Engine Management / Tuning Forums
49
Aug 23, 2012 09:50 PM