EVO is pulling timing no knock
#16
Newbie
Thread Starter
Keep in mind that TephraMod 1-byte load will read higher than the load that is used in the spark map, which is baro compensated load plus modifiers like air temp subtraction.
If your 1-byte factor is 1.2 your measured load will top out at 306, this is why you would change it to read higher, but the 1-byte value in EvoScan has to match whats in your rom.
If your 1-byte factor is 1.2 your measured load will top out at 306, this is why you would change it to read higher, but the 1-byte value in EvoScan has to match whats in your rom.
-so my timing map load bar isn't matching my 1-byte load evoscan reading because in the ignition map, load will top out at 350 witch should be topping out at 306 according to my 1-byte factor .
- As i understand i need to re-scale my load bar to match my load factors right?
Thread
Thread Starter
Forum
Replies
Last Post
EvilDSM97
ECU Flash
3
Aug 29, 2022 09:02 AM
Live4Redline
ECU Flash
4
Jun 26, 2015 10:53 AM
GTR2009
Evo X Engine Management / Tuning Forums
12
Jul 22, 2009 12:46 PM