fabiano

Hi,

what needs to be adjusted to configure the 4 Bar Omni Map sensor to 96531706 (Tephra SD)?

found this thread
https://www.evolutionm.net/forums/ec...evo-8-9-a.html
but different rom versions and the table defs are removed.

ronaldo9

iTrader: (2)

That is a universal rom for the evo 8. I did not have to adjust anything in the rom if I remember correctly. I am using 96530706. If you use a USDM rom though your car may not start unless you alter the values for the map sensor. All I did was verify the equation in Evoscan to make sure I was reading the correct boost pressure.

Fox_IX

They weren't removed.

You need to view source on the thread and you'll see the defs.

fabiano

Thanks!!!!

Another short question, where is my map sensor?
I've got an evo 8 (and evo 8 ecu) but intake manifold is maybe from a evo 6

CDrinkH2O

iTrader: (7)

You don't have one! It's normally mounted in the blanked out hole on top of the manifold. https://www.evolutionm.net/forums/at...hmentid=104120
Guess it's time to get an Evo 8/9 inlet manifold.

fabiano

Thanks, Can you make a picture where the map plug comes from?

CDrinkH2O

iTrader: (7)

Here you go.

fabiano

thanks again! ;-)

I already searched for the connector on the loom and I fear that its also missing in the loom ;-(
****