EVO IX 8859 comes out of open loop at idle
Feb 5, 2018, 05:03 AM
#1
EVO IX 8859 comes out of open loop at idle
Hi all,
Something that is starting to get on my nerves, I am trying to run a lean idle and have all of the open loop load tables set to 0 in the idle areas.
When I start the car, it will idle at my target AFR, if I blip the throttle it will then idle back down and somehow go into closed loop and sit at 14.7. It will not go lean again until a reflash.
I had the idle where I wanted it for a few days with no changes, then this started happening for no reason, now I cannot get it to stay in open loop.
Any ideas?
Something that is starting to get on my nerves, I am trying to run a lean idle and have all of the open loop load tables set to 0 in the idle areas.
When I start the car, it will idle at my target AFR, if I blip the throttle it will then idle back down and somehow go into closed loop and sit at 14.7. It will not go lean again until a reflash.
I had the idle where I wanted it for a few days with no changes, then this started happening for no reason, now I cannot get it to stay in open loop.
Any ideas?
Feb 5, 2018, 05:28 PM
#2
The car starts in open loop and does not change to closed loop until the coolant temp hits 84 deg F. Open Loop Throttle #1 & 2 also need to be set to 0% at idle RPMs. The logic used for the transition to open loop is coolant temp > 84 deg F and either load or throttle exceeds the value in the respective open loop table.
Last edited by CDrinkH2O; Feb 5, 2018 at 05:35 PM.
Feb 5, 2018, 05:50 PM
#3
The car starts in open loop and does not change to closed loop until the coolant temp hits 84 deg F. Open Loop Throttle #1 & 2 also need to be set to 0% at idle RPMs. The logic used for the transition to open loop is coolant temp > 84 deg F and either load or throttle exceeds the value in the respective open loop table.
Thank you.
Thread
Thread Starter
Forum
Replies
Last Post
Slava
ECU Flash
5
May 7, 2007 06:11 AM
silverstream
General Engine Management / Tuning Forum
1
Oct 2, 2006 08:34 AM