Simon Pugmire

iTrader: (3)

ok i have been searching everywhere. I just bought a 06 evo 9 bone stock. I am looking to start modding it and i cant seem to get the evoscan to work with it. I have openport 2.0 instead of the 1.3 and i have the reflash adapter. The part i cant figure out is what settings to do i use for this? My evox was easy to setup and start logging and tuning with.
i use the 2.0 settings, can 2006+/evox and mode 23 USA evoX. i just cant figure out how i will go about getting the settings all figured out for the evo 9. If someone can help me out it would be GREATLY appreciated.

todd6027

iTrader: (10)

select mitsubishi mut 111 just below where you select cable , then bottom right above actuators select obd 2 efi (all 96-06,, 7/8/9 ) try connect if it doesnt change baud rate 15625 to 62500 and try again just incase it was ever changed .

Simon Pugmire

iTrader: (3)

i changed the settings and it didnt switch the braud rate. i will go try logging it this way and see how it goes

Simon Pugmire

iTrader: (3)

so test drove it and when i come to a stop my anti lock brake light flashes and so do my acd lights. Is this normal when data logging?

ronaldo9

iTrader: (2)

I believe this happened to me until I pulled Pin 9 on the plug but I had the 1.3u cable.

Simon Pugmire

iTrader: (3)

tried folding it down and still have the same flashy lights. the second i stop logging or start driving, only does it when sitting at idle.

Biggiesacks

thats normal, its just indicating the ecu is in diagnostic mode

todd6027

iTrader: (10)

As above quiet normal

ronaldo9

iTrader: (2)

See screen shot. If you go to logging in evoscan look at the first check mark in my photo.

Simon Pugmire

iTrader: (3)

ahh that must be my issue. now i know what it does when in diagnostic mode. thank you ronald next time i head out to log i will see if that fixed it