Evo 9 wont connect with ecu flash
#1
Newbie
Thread Starter
Evo 9 wont connect with ecu flash
Just trying to do a read my ecu and flash in the tephra no lift shift feature.
so far ive tried
- running the un-locker program.
-key in on position, both plugs connected
-I made sure the car had good voltage, even connected a trickle charger at one point. -I tried version 1.44, wouldn't read but it does connect to the openport wire. Version 1.39 freezes on me when I click read.
my computer is older but not junk. Im running windows vista 32 bit, the openport wire is a old 1.3
my next step is to try a new computer but im open to suggestions.
Any fuses I should check ? or another version?
so far ive tried
- running the un-locker program.
-key in on position, both plugs connected
-I made sure the car had good voltage, even connected a trickle charger at one point. -I tried version 1.44, wouldn't read but it does connect to the openport wire. Version 1.39 freezes on me when I click read.
my computer is older but not junk. Im running windows vista 32 bit, the openport wire is a old 1.3
my next step is to try a new computer but im open to suggestions.
Any fuses I should check ? or another version?
#2
Newbie
Thread Starter
Bump ? Tired 3 different computers now. Same issue, tired versions 1.39 and 1.42 and 1.44.
My other thought is the wire is very old, it's likely a 1.2?
I've read some stuff about having rom files loaded ? But I don't think it applies to me.
My other thought is the wire is very old, it's likely a 1.2?
I've read some stuff about having rom files loaded ? But I don't think it applies to me.
Thread
Thread Starter
Forum
Replies
Last Post
kirk212
Evo X Engine Management / Tuning Forums
13
Apr 6, 2010 12:40 PM