Evoscan data displaying on graphs
#1
Newbie
Thread Starter
Evoscan data displaying on graphs
Finally got my hardware sorted so I can log the WBO2 and the MAP sensor, yet Evoscan doesnt display the boost signal on the AFR map when doing power runs, it only shows AFR. I tried logging both JDM MAP, and Boost (MAP), neither show up on the graph when doing power runs, yet it logs them fine. Well, sort of fine, usually the psi reading is about 2psi below what the gauge displays.
Is there a way to display data as like a line graph over time, say I wanted to watch RPM/Boost/WBO2/WGDC on a graph. Or do I have to do something with excel?
Im not a pro with Evoscan, theres probably ways to do all this, I just dont know how.
Is there a way to display data as like a line graph over time, say I wanted to watch RPM/Boost/WBO2/WGDC on a graph. Or do I have to do something with excel?
Im not a pro with Evoscan, theres probably ways to do all this, I just dont know how.
#3
Thread
Thread Starter
Forum
Replies
Last Post
evo4mad
ECU Flash
180
Jun 7, 2007 05:06 PM
hardcoretuner
General Engine Management / Tuning Forum
2
Jul 23, 2006 08:26 PM
nutrulz
General Engine Management / Tuning Forum
10
Aug 10, 2005 03:24 AM