Sketch sound after flash to stock
#1
Newbie
Thread Starter
Sketch sound after flash to stock
cant think of a word that would describe this sound but it resembles a whining noise you would get when cranking an old school beyblade where teeth would be cranking on a gear. Anyways I reflashed my car back to stock, and, during testing, that sound came up when idling. Also, after it cooled down, the car sounded completely fine afterwards. No leaks whatsoever so I figured it was the tune. My original tune had a complete exhaust setup, intercooler, and it's cammed, and now everything went back to stock other than the new Omni 4 bar, grimmspeed ebsc, and the cams. Afr's weren't crazy either sitting at 13.8 +/- 1.0
on the other hand, this could also be the water pump since it hasn't been replaced from factory and the mileage didn't reach 60k yet--which would be a factor since it just started to get warm at around 70 degrees in sf
on the other hand, this could also be the water pump since it hasn't been replaced from factory and the mileage didn't reach 60k yet--which would be a factor since it just started to get warm at around 70 degrees in sf
Last edited by k0lok0yboi; Jul 20, 2017 at 02:34 PM.
#3
Newbie
Thread Starter
A better way to describe the sound would be a ratchet moving backward or your parking brake engaging and hitting the notches. Those sounds but toward the passenger side by the engine. Timing off?
Thread
Thread Starter
Forum
Replies
Last Post