Tephra V3 alt maps switching - how ?!?
#1
Evolving Member
Thread Starter
Join Date: Jul 2009
Location: Moscow, Russia
Posts: 226
Likes: 0
Received 0 Likes
on
0 Posts
Tephra V3 alt maps switching - how ?!?
Guys, I can't figure out how to switch alt maps in V3 ? Can someone advise me how to do it ?
In old versions I could enable it to switch using throttle pedal, in V3 can't find such option.
In old versions I could enable it to switch using throttle pedal, in V3 can't find such option.
Last edited by YaroRS; Jun 23, 2017 at 10:41 PM.
#2
Evolving Member
iTrader: (1)
In the rom, you need to indicate how many alternate maps you want (1-9) then after you have flashed the car, either while the car is running or ignition on, hold the on/off Cruise control button on the wheel. You will see the intercooler spray light flash on and off. While it is flashing, press up or down on the raise decrease cruise control buttons, 1 for up 1 map from where you are at, twice for two maps up and so forth. When you are done, the intercooler spray light will flash the amount of times that signifies your map number, 1 flash for map 1, 2 flashes for map 2 and so forth. No flashes means you are on the base map
#3
Evolved Member
I've got Tephra's XMod v3 on Ralliart. To switch maps, I do the following:
- Hold down Cruise Control button until the CEL starts flashing.
- Press the cruise UP (or DOWN) button to swich maps.
It will then flash the ICS (intercooler spray) indicator on the dash to indicate the map number (no flashes = main map, 1 flash - Alt Map #1, etc.)
And that's it.
Rich
- Hold down Cruise Control button until the CEL starts flashing.
- Press the cruise UP (or DOWN) button to swich maps.
It will then flash the ICS (intercooler spray) indicator on the dash to indicate the map number (no flashes = main map, 1 flash - Alt Map #1, etc.)
And that's it.
Rich
Thread
Thread Starter
Forum
Replies
Last Post