Switched to Speed Density 2.0 and getting P0105
#1
Switched to Speed Density 2.0 and getting P0105
I made the switch yesterday and now i am getting this code which is essentially Baro failure. Is this the old spoolin up harness that is causing this? I thought this used a Fixed Baro value and the error should be disabled. I dont see anything in the Map that jumps out at me as wrong....did i miss something?
Thread
Thread Starter
Forum
Replies
Last Post
evohq
General Engine Management / Tuning Forum
0
Feb 21, 2016 06:49 AM
CrackerJackToy
Evo Engine / Turbo / Drivetrain
8
Feb 8, 2008 07:47 AM