Deleting Rear o2 wires
#1
Deleting Rear o2 wires
Hello Guys,
I'm depining/deleting lots of wiring for my track car. Not registered, not street driven etc.
Can I delete the Rear o2 wiring/sensor if its disabled in ECU Flash? Same for OE boost solenoid?
I've already removed EGR/EVAP/FP Solenoid/AC wiring/Front impact sensors etc.
While I've got the engine harness out I'd like to remove the rear o2 wiring, boost solenoid wiring, MAF wiring etc just not sure if this is going to cause a problem with a SD ECU Flash setup.
Thank you in advance.
I'm depining/deleting lots of wiring for my track car. Not registered, not street driven etc.
Can I delete the Rear o2 wiring/sensor if its disabled in ECU Flash? Same for OE boost solenoid?
I've already removed EGR/EVAP/FP Solenoid/AC wiring/Front impact sensors etc.
While I've got the engine harness out I'd like to remove the rear o2 wiring, boost solenoid wiring, MAF wiring etc just not sure if this is going to cause a problem with a SD ECU Flash setup.
Thank you in advance.
#2
EvoM Community Team Leader
yes you can remove it, but leave the sensor input pin in the ecu side of the connector, you can use the input for logging.
Thread
Thread Starter
Forum
Replies
Last Post
ajnasrah20083
Evo How Tos / Installations
21
Jul 8, 2014 07:07 PM
Standing Z
Evo Electrical / Audio / Security
6
Aug 9, 2009 07:29 PM
EvoDan2004
ECU Flash
2
Jul 21, 2008 04:44 AM
g0damy0uugly
Lancer Audio and Security (All models)
6
Jul 29, 2004 11:02 PM