Changing ECUflash Default COM/USB port
#1
Changing ECUflash Default COM/USB port
Hi Gents,
I apologize if this has been answered, but I searched and could not find any info on this.
I seem to be having a tough time with ECU flash when both my wideband rs232 usb cable and tactrix cable are plugged in. The software defaults to using the rs232 cable unless I unplug it, which of course causes a "fail to read from ECU" message. I checked under the "Flashing" setting in the options, but the menu is blank. Is there an .ini/setup file that could be adjusted to make ECU flash uses the proper USB port?
The version is: 1.44.4341
Thanks for your help.
I apologize if this has been answered, but I searched and could not find any info on this.
I seem to be having a tough time with ECU flash when both my wideband rs232 usb cable and tactrix cable are plugged in. The software defaults to using the rs232 cable unless I unplug it, which of course causes a "fail to read from ECU" message. I checked under the "Flashing" setting in the options, but the menu is blank. Is there an .ini/setup file that could be adjusted to make ECU flash uses the proper USB port?
The version is: 1.44.4341
Thanks for your help.
Last edited by Pal215; Dec 12, 2017 at 01:32 PM.
Thread
Thread Starter
Forum
Replies
Last Post
Tsurara
Northeast Region
0
Sep 3, 2007 08:36 PM
mvm42699
General Engine Management / Tuning Forum
17
Aug 23, 2004 06:30 AM