Omni 3 bar settings - EvolutionM - Mitsubishi Lancer and Lancer Evolution Community

Notices
EcuFlash
Sponsored by:
Sponsored by:

Omni 3 bar settings

Reply

 
 
 
Old Mar 6, 2018, 05:42 AM
  #1  
Evolved Member
Thread Starter
 
foxbat's Avatar
 
Join Date: Oct 2009
Location: UAE
Posts: 858
Thanked 9 Times in 9 Posts
Omni 3 bar settings

I've been tuning an Evo 7 using Tephra 9055 V7 SD, the map sensor is a bolt-on Omni 3bar, I used the default map sensor scaling in the rom by switching 'Map Sensor KPA' table scaling to Omni 3bar. The values are:
Map volts--- KPA
0.9 -----------1.0
15.4---------- 20
24 ------------30
32 ------------42
50.1 ----------66
88.2 ----------117
143.2 --------190
362.1 --------430
I suspect that the scaling is off because, first, I had to scale the RC1200 injectors to 1270 to prevent the car from running rich at idle, second, I'm hitting very high load numbers, more than 360 although max boost was around 27PSI only. The car is 2.3L Gen2 GTX3576, ported head & intake manifold is expected to hit high loads but not by that much.
I'd appreciate your feedback
foxbat is offline  
Reply With Quote
 
 
 


Thread Tools
Search this Thread

Contact Us Archive Advertising Cookie Policy Privacy Statement Terms of Service

We are a participant in the Amazon Services LLC Associates Program, an affiliate advertising program designed to provide a means for us to earn fees by linking to Amazon.com and affiliated sites.