EvoScan - Excel files repeats values every 27 cells
#1
EvoScan - Excel files do not display any data accurately
Hi everyone,
I am currently trying to log my '04 Evo. When I plug into the the car everything is fine. When I log and open the files in excel, the numbers and values (all) repeat after like 17 cells or so .Also I noticed when I am at idle, 925~ RPMS, the rpm on range on Evo scan is going from 0 to 2300, to 1100.. Maybe I need a new cable? When I give it a rev to 3K, evo scan does numbers are alternating between. Coolant temp numbers are not accurate at all. I believe most of this data is not accurate and EvoScan is opening and just displaying the same data over and over again...
Anyone ever have this type of issue before?
Thank you!
I am currently trying to log my '04 Evo. When I plug into the the car everything is fine. When I log and open the files in excel, the numbers and values (all) repeat after like 17 cells or so .Also I noticed when I am at idle, 925~ RPMS, the rpm on range on Evo scan is going from 0 to 2300, to 1100.. Maybe I need a new cable? When I give it a rev to 3K, evo scan does numbers are alternating between. Coolant temp numbers are not accurate at all. I believe most of this data is not accurate and EvoScan is opening and just displaying the same data over and over again...
Anyone ever have this type of issue before?
Thank you!
Last edited by EVOEvolved; May 12, 2018 at 07:11 AM.
#2
EvoM Community Team Leader
a couple things to check, your baud rate should be 15625, you should have the proper openport cable selected for which ever you are using 1.3x or 2.0, It should be set to "Mitsubishi MUTIII", make sure "offline Test Mode" is not checked.
Thread
Thread Starter
Forum
Replies
Last Post
9!'clipseDOHC
General Engine Management / Tuning Forum
57
Sep 2, 2012 10:20 PM
johnnnyjeans
Cobb AccessPORT
3
Jun 4, 2012 09:30 AM